Based on your detected country, we suggest the draperinc.com domain for the best experience.

US Dollar Exchange Rate is currently 1.33.

Closures for Type D Pockets or Wall Clip

Product Description

Depending on the existing pocket size, Closures for Type D Pockets or Wall Clip offers three different closure panels for use with Pocket D Headboxes or Wall Clips. Field notching for chain clearance is required on larger closure panels.

Hardware Options

Fabric Options

Large Format Printing

Ready to purchase

Product Specs

Extrusion comes in 12’ 3" (374 cm) long sections and must be cut to fit the space available. Draper can also cut to size.

Extrusion comes in 12’ 3" long sections and must be cut to fit the space available. Draper can also cut to size.

Depending on the size of pre-existing pockets, wall clips (with or without tile lip) accommodate 1-½”, 3”, or 5” panels.

Wall clips (with or without tile lip) accommodate 1-½” (38 mm), 3” (38 mm), or 5” (127 mm) panels, depending on the size of the pre-existing pocket.

1-½” (38 mm) panel is for a manual FlexShade mounted in a Type D Pocket Headbox. No notching required for chain clearance.

1-½” panel is for a manual FlexShade mounted in Type D Pocket Headbox. No notching required for chain clearance.

3” panel is for a manual FlexShade mounted in Type D Pocket Headbox. No notching required for chain clearance.

3” (76 mm) panel is for a manual FlexShade mounted in a Type D Pocket Headbox. No notching required for chain clearance.

The 5” (127 mm) closure is for use with wall clip only.

The 5” closure is for use with wall clip only.

ANSI/WCMA A100.1 Compliance

If clutch-operated roller shades are installed in an environment where it's possible that young children will be present, they should comply with ANSI/WCMA A100.1, the Standard for Safety of Window Coverings.

If the shades that you purchase need to comply with this standard, it is your responsibility to inform Draper and opt-in to receive compliant products at time of order.

Compliant window shades will include:

Pre-installed spring-loaded chain tension device with bead chain threaded through it
Approved permanent warning label attached
Approved mechanical fasteners for the tension device included

If the tension device is not installed properly, or becomes unattached from the mounting surface, the shade will be rendered partially inoperable. If installed properly, the tension device will prevent the creation of a hazardous loop and will maintain tension on the bead chain. The tension device and label require tools to be removed.