Based on your detected country, we suggest the draperinc.com domain for the best experience.

US Dollar Exchange Rate is currently 1.33.

Type D Pocket

Product Description

The Type D Pocket features an extruded aluminum pocket headbox complete with tile lip for ceiling-recessed installation. The Type D can accommodate either a motorized or a manual FlexShade. Installation of the headbox during the initial phase of construction helps eliminate job site damage and allows the shade to be installed later. Compatible with single roller endcaps or mounting brackets. Not suitable for all products/sizes.

Hardware Options

Fabric Options

Large Format Printing

Ready to purchase

Product Specs

Headbox comes in 12’ 3" long sections. It must be cut to fit the space. Draper can also cut to size.

Extrusion comes in 12’ 3" (374 cm) long sections and must be cut to fit the space available. Draper can also cut to size.

Headbox dimensions: 5-3/8" h x 5" d. Tile support lip dimension: 7/8".

Headbox dimensions are 5-3/8" (137 mm) h x 5" (127 mm) d. Tile support lip dimension is 7/8" (22 mm).

Product compatible with single roller endcaps or mounting brackets. Not suitable for all products/sizes.

Panel dimensions for motorized shades are 3" (76 mm) and for clutch-operated shades 1-1/2" (38 mm). Larger closure panels require field notching for bead chain clearance.

Bottom closure panel is removable.

Bottom closure panel is removable.

Available in white (standard).

Fixed lip along lower edge supports lay-in ceiling at bottom edge.

Can be used with the FlexShade Coupler.

Accommodates clutch-operated or motorized FlexShade.

ANSI/WCMA A100.1 Compliance

If clutch-operated roller shades are installed in an environment where it's possible that young children will be present, they should comply with ANSI/WCMA A100.1, the Standard for Safety of Window Coverings.

If the shades that you purchase need to comply with this standard, it is your responsibility to inform Draper and opt-in to receive compliant products at time of order.

Compliant window shades will include:

Pre-installed spring-loaded chain tension device with bead chain threaded through it
Approved permanent warning label attached
Approved mechanical fasteners for the tension device included

If the tension device is not installed properly, or becomes unattached from the mounting surface, the shade will be rendered partially inoperable. If installed properly, the tension device will prevent the creation of a hazardous loop and will maintain tension on the bead chain. The tension device and label require tools to be removed.